KIRLOSKAR HORIZONTAL AXIALLY SPLIT CASING PUMPS TYPE : DSM

รายละเอียดสินค้า

RANGE Delivery size up to 150 mm. Capacity up to 470 m3/hr. Head up 180 metres. APPCICATIONS Suitable for Water Works. Circutation of Water in Air-Conditioning Plant. Power Station. Mine Drainage, Lift Irrigation, Fire Fighting,Paper and sugar Mills, Steel Plants etc, Can be used for Handling Slighty contaminated liquids. CONSTRUCTIONAL FEATURES These are horizontal axially split casing, two stage, single suction, pumps with horizontal shaft. Variety of models are available to operate at 50 Hz and at 60 Hz. SPECIFICATION End suction, balut type with top centreline discharge. Suction and discharge nozzles as well as the supporting Feet are cast integral with the casing. SPECIAL FALTURES * Direct or gear drive * Rotating assembly available for inspection or maintenance by removing only upper half casing without disturbing suction or delivery piping and motor * Highest hydraulic and overall efficiency due to latest design and manufacturing techniques * Very high efficiency in the operating range * Good suction performance and low NPSH * Stable characteristics * Minimum maintenance required * Vibration-free performance * Highest reliability CASING Horizontal axially split valute type, suction and discharge nozzles and supporting feet cast integral with lower half casing. IMPELLER Enclosed type accurately balanced impellers are placed back to back to balance axial thrust load. SHAFT The high tensile steel shaft accurately machined and ground is supported by antifriction bearings. The shaft is protected by shaft sleeves from wear in stuffing box area. STUFFING BOX The stuffing box can be sealed by gland packing or by mechanical seal and is suitable for liquids having temperature up to 90 oC BEARINGS Deep groove ball/roller bearings are provided. Standard lubrication is grease. DIRECTION OF ROTATION Standard - Clockwise/Anticlockwise viewed from driving end depending upon model. Optional - Models with reverse rotation are available upon request. DRIVE Suitable for coupling with electric motors, I.C. engines or steam turbines either directly or through belt drives. FLANGES Standard : Drilling as per BS-10 Table D or BS 4504 Table 16/11 (Raised face) depending upon model. Optional : DIN/ASA with suitable pressure rating.